Invacare pronto R2 series Owner's Operator And Maintenance Manual page 22

PROCEDURE 3
Warning
Label
F
R Large Washer
O
Locknut
N
T
R
Hub Cap
I
G
G
Caplug
I
Washer
N
G
NOTE: Calf-pads not shown for clarity.
S
FIGURE 17 - ADJUSTING THE CALF-PAD HEIGHT
Adjusting the Calf-Pad Width (FIGURE 18)
1. Loosen, DO NOT remove the two (2) phillips head
screws and washers that secure the calf-pad to the
calf-pad bracket.
2. Slide the calf-pad left or right until the desired width
is achieved.
Calf pad width adjustment may be limited by
other chair components. Ensure calf pad will
clear full up and down travel of front stabilizer
assemblies. Otherwise, damage to the calf
pad may result.
3. Tighten the two (2) phillips head screws and wash-
ers that secure the calf-pads to the calf-pad bracket.
4. Repeat STEPS 1-3 for opposite side if necessary.
5. If necessary, replace the one piece footboard. Re-
fer to INSTALLING THE ONE PIECE FOOTBOARD
in this procedure of the manual.
Mounting
Bolt
Hub Cap
Caplug
Washer
Large
Washer
Pivot Bracket
Footboard
CAUTION
CAUTION
DO NOT use outside mounting slots, otherwise
damage to the calf-pads may occur.
Calf-Pad
Phillips Head
Screws and
Washers
FIGURE 18 - ADJUSTING THE CALF-PAD WIDTH
Adjusting the Calf Pad Angle (FIGURE 19)
1. Loosen, DO NOT remove, the two (2) mounting
screws and locknuts that secure the calf-pad
bracket to the pivot bracket.
2. Rotate the calf-pad to the desired angle.
3. Securely tighten the two (2) mounting screws and
locknuts that secure the calf-pad bracket to the calf
bracket.
4. Repeat STEPS 1-3 for opposite calf-pad if neces-
sary.
Calf-Pad
Bracket
Mounting Screws
and Locknuts
Pivot Bracket
FIGURE 19 - ADJUSTING THE CALF-PAD ANGLE
22
FRONT RIGGINGS
Calf-Pad
Bracket
Calf-Pad