Appendix; Care; Contact With Liquid; Questions And Answers - BELGACOM Twist 608 User Manual

Appendix

Care

¤
Wipe the base station, charging cradle
and the handset with a damp cloth (do
not use solvent) or an antistatic cloth.
Never use a dry cloth. This can cause a
build up of static.

Contact with liquid

If the handset has come into contact with
liquid:
1. Switch the handset off and remove
the batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours
(not in a microwave, oven etc.).
4. Do not switch on the handset again
until it is completely dry.
When it has fully dried out, you will nor-
mally be able to use it again.

Questions and answers

The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not turned on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge or replace the batteries
(page 7).
The keys of a handset do not respond when
pressed.
The keypad lock is activated.
¥
Press and hold the hash key
(page 10).
!
a
.
#
"Base station x" flashes on the display.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the base sta-
tion.
The base station's range is reduced because
eco mode is activated.
¥
Deactivate eco mode (page 12) or
reduce the distance between the hand-
set and the base station.
2. The handset has been deregistered.
¥
Register the handset (page 30).
3. The base station is not turned on.
¥
Check the base station's mains adapter
(page 7).
Base Search flashes in the display.
No base station turned on or in range.
¥
Move the handset closer to the base sta-
tion.
¥
Check the base station's mains adapter
(page 7).
Handset does not ring.
1. The ringer tone is switched off.
¥
Activate the ringer tone (page 37).
2. Call diversion set to
¥
Deactivate call diversion (page 17).
You cannot hear a ringer/dialling tone from
the fixed network.
The phone cord supplied has not been used or
has been replaced by a new cord with the
wrong jack connections.
¥
Please always use the phone cord supplied.
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (page 39).
Forgetting the system PIN.
¥
Reset the system PIN to 0000 (page 39).
The other party cannot hear you.
u
You have pressed the
set is "muted".
¥
Activate the microphone again (page 16).
Appendix
All Calls.
(INT) key. The hand-
41