Makita BUK360 Instruction Manual page 10

CAUTION:
Always be sure that the transport wheel is in the
•
transporting position before you adjust the drag bar.
1. Remove the stopper which holds the drag bar.
2. Adjust the position of the drag bar, then hold the
position with the stopper.
Positioning guide
Deep cultivation - A
•
Middle depth cultivation - B
•
Shallow cultivation - C
•
Transport position - D
•
NOTE:
If the field is solid and the tool advances too fast,
•
set the drag bar at the deep cultivation position - A.
If the field is soft and the blade sinks in the field, set
the drag bar at the shallow cultivation position - C.
When you transport the tool, place the drag bar at
•
transport position - D.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying
out any work on the tool. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the drag bar and stopper
1
012990
To install the drag bar with stopper, refer to the section
titled "Drag bar" in FUNCTIONAL DESCRIPTION.
1. Drag bar
2. Stopper
2
Setting the lock key
012843
To set the lock key, refer to the section titled "Power
switch action" in FUNCTIONAL DESCRIPTION.
Assembling and adjusting the angle of the
handle
CAUTION:
Always perform the adjusting on the flat surface to
•
avoid accidents.
Always be sure that the transport wheel is in the
•
transporting position before you adjust the angle of
the handle.
Always hold the handle while adjusting, or the
•
handle may fall on person and cause injuries.
012831
1
2
012939
1
2
012991
10
1. Lock key
1
1. Handle locking
knob
1
1. Corn spring
2. Handle locking
knob
1. Handle locking
knob
2. Tighten