Advertisement
Installing or removing abrasive disc
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the disc.
NOTE:
Use sander accessories specified in this manual. These must be purchased by separate.
Mount the rubber pad onto the spindle. Fit
the disc on over the rubber pad and screw
the
lock nut onto the spindle.
To
tighten the lock nut, press the shaft lock
firmly
so
that the spindle cannot revolve,
then use the lock nut wrench and securely
tighten clockwise.
Lock
nut
.
. _
Abrasive disc
Rubber
pad
I
r -
--
Lock nut wrench
I
\
Shaft lock
To remove the disc, follow the installation procedure in reverse.
7
Advertisement
