Connecting The Printer Using Access Point (Soft Ap) Mode; Connecting The Printer To Your Computer (Mac); Connecting The Printer Using Usb - LEITZ ICON User Manual

Leitz Icon Printer User Guide
6.From the list of available wireless networks, select your wireless network, and then click Connect.
7.When prompted, enter the password for your wireless network, and then click OK.
The printer is connected to your wireless network and added to the computer and is now available for printing.

Connecting the Printer Using Access Point (Soft AP) Mode

The printer can act as its own access point, or Soft AP, allowing a direct wireless connection between the printer and your
computer. Using access point mode, you can wirelessly connect the printer to your computer without connecting to an
existing wireless network.
To connect the printer using access point mode
1.In the Add Printer Wizard, select Wi-Fi, and then click Next.
2.Click Soft AP, and then click Next.
3.From the list of available wi-fi access points, select the printer ID of the Leitz Icon printer you want to connect to your
wireless network, and then click Connect.
The Printer ID is formatted as ICON-xxyyzz and can be found on the label on the bottom of your printer.
If the label on the bottom of your printer does not contain the Printer ID, you can determine the Printer ID using the printer's
NOTE
MAC address. In this case, the Printer ID is formatted as ICON-xxyyzz, where xxyyzz is the last six characters of your
printer's MAC address (found on the label on the bottom of your printer). For example, if your printer's MAC address is
MAC:00:1E:CO:13:13:A5, the Printer ID is ICON-1313A5.
4.Enter your user name and password in the User name and Password boxes.
The default user name and password are as follows.
User name: Admin
Password: password
The printer is now available for printing.

Connecting the Printer to Your Computer (Mac)

Several options are available for connecting the Leitz Icon printer to your computer.
• Connect the printer using USB
• Connect the printer using your wireless network
• Connect the printer using access point (Soft AP) mode
Software installation must be complete before connecting the printer to your computer.
NOTE

Connecting the Printer Using USB

After downloading and installing the software, connect the power to the printer (see Connecting the Power) and attach
the USB cable to your computer.
Software installation must be complete before connecting the printer to your computer.
NOTE
1.Plug the USB cable into the USB connector located on the back of the printer.
2.Plug the other end of the USB cable into an available USB port on your computer.
The necessary driver to print to your printer is installed. Once the installation is complete, you will be able to print your
first label.
10
Getting Started