④
Turn the device upside down and
then turn the screws in firmly.
⑦
Put the cover in accordance with the
clip and then place the upper cover
back.
1.4.2 CJ-HDR416
This product supports four SATA HDDs. Please use HDD of 7200rpm or higher.
○
1
Loosen the screws of the
upper cover.
○
4
Unfasten the HDD power
cable.
Important
You can connect the HDD data cable and the power cable first and then fix the HDD in the
device.
Please pay attention to the front cover. It adopts the vertical sliding design. You need to
push the clip first and then put down.
⑤
Fix the HDD firmly.
⑧
Secure the screws in the rear panel
and the side panel.
○
2
Line up the HDD to the four
holes of the HDD bracket.
○
5
Use the special data cable to
connect the HDD and the SATA port
⑥
Connect the HDD cable and
power cable.
○
3
Use four screws to fix HDD.
○
6
Insert the HDD power cable.
Close the chassis and fix the
screws to secure firmly.
2