Table of Contents
Advertisement
and let the dishwasher run for about 20
Changing Panels
minutes. Stop the dishwasher by unlatching
the door and let stand overnight. Then,
Your Jenn-Air dishwasher comes with reversible
restart the dishwasher by latching the door
panel inserts which are pre-assembled at the
and let it complete the cycle,
factory. This enables you to select the color you
want before your dishwasher is installed or
2. Select the Light cycle and let the dishwasher
choose another color at a later date.
fill with water. Then open the door and
pour 1/4 cup of chlorine bleach into the
TO Change Panels:
bottom of the dishwasher. Latch the door
A. Remove three screws holding the metal
and let the dishwasher complete the cycle,
trim strip on one side of the door. Take note
Do not use detergent,
of how the trim comes off.
Clean the control panel and front panel with a
B. Grasping the lower part of the door panels,
soft damp cloth and liquid spray cleaner. Do
bow panels out carefully at the bottom
not use any abrasive powders or cleaning pads.
while sliding panels far enough to clear the
Winter Storage
flange on the trim strip which was not
removed and remove panels.
CAUTION: To protect against rupture of fill
C. Arrange panels so the desired color is
valve, BESUREthe water lines leading to the
dishwasher, are well protected against
facing out.
freezing.
D. Place door panels (notched side up) behind
1. Run dishwasher through a cycle using
the metal trim at the bottom of the door.
detergent. If an odor remains, repeat using
Bow the panels so they fit behind the
baking soda in the dispenser cup or adding
control panel at the top.
1/4 cup of chlorine bleach in the bottom of
E. Slide the panels under the side metal trim
tub. Clean the bottom edge of the door and
which was not removed. To do this, it will
front lip of the tub with a baking soda and
be necessary to compress the backing
water solution,
behind the colored panels.
2. Turn the water supply off and drain the
F. Reinstall the metal trim which was removed
dishwasher (press the Drain/Off pad).
earlier. To do this, start by inserting the tip
Repeat this procedure to remove as much
end of the trim strip behind the control
water as possible,
panel. Align the holes and replace the three
3. Disconnect the electrical supply,
screws.
4. Place a pan under the drain outlet.
G. The lower access panel is held by four
Disconnect the valve at the inlet and outlet
screws (two above the panel and two
and drain the water into the pan. Leave the
below). With these removed, the panel may
dishwasher disconnected,
be removed to make it easy to change
5. Place the pan under the drain outlet,
panel colors.
Disconnect the flexible tubing from the
H. With the lower access panel removed,
pump and drain the water into the pan.
remove the four screws along the bottom
Repeat the procedure at the upper hose
of panel and remove the trim which holds
outlet. Leave both hoses disconnected,
the panels. Once the desired panel is facing
out, replace the trim, and reinstall the panel
6. Prop the door open.
to the dishwasher.
To restore service, reconnect the fill valve and
Use care when changing panels to be certain
connect both sides of the pump module. Turn
you are not injured on sharp edges and that
on the electricity and water supply. Select a
the panels are not damaged. If you have any
wash cycle and let the dishwasher complete
questions concerning changing panels, contact
the cycle. Check connections to make sure
they are water tight,
your local Jenn-Air dealer.
PAGE13
Advertisement
Table of Contents
