Special Functions - Jenn-Air DW980B-CAN Use & Care Manual

or Rinse & Hold will start the dishwasher Delay:
(Note: The fill will begin after a brief pause). Pressing the Delay pad can delay or interrupt
The indicator light for the selected cycle any cycle from 10 minutes to 12 hours.
will glow. To delay a cycle, press the Delay pad, holding
it down until the desired amount of delay time
Display Window: appears in the display. When first pressed, 10
The display window tells what is happening in MIN. will appear and increase in 10 minute
the dishwasher. Phasesof the cycle and increments until 1 HOUR appears.
minutes remaining are displayed. Further increases in the delay time will be in
Cycle Sequence Indicator: one hour increments until 12 hours is reached.
The six segment vertical bar and words Select a cycle and dry option after choosing
represent the portions of the cycle to indicate the desired delay period. The dishwasher will
the phase of the cycle in progress--PRE- automatically start as soon as the delay time
WASH, WASH, RINSEor DRY.At the end of the expires.
dry phase, CLEAN will remain lit until the door DELAY will remain in the display until the clock
is opened, has counted down. Delay can be cancelled by
Special Indicators: pressing the Delay pad a second time. The
RINSED ONLY - appears after a Rinse & Hold cycle selected will begin immediately.
cycle. This feature can also be used to temporarily
interrupt a cycle. The cycle will resume from
HEATING DELAY- appears when AccuTemp is the point of interruption when the delay time
selected and the water temperature is low.
The main wash is extended to heat the water runs out or when the Delay pad is pressed
to the proper temperature, again.
DELAY- appears when the Delay pad is Adding a Forgotten Item:
pressed to show the time length of the delay.
For best cleaning, the forgotten item should be
PF- appears when there has been a power added early in the cycle.
failure. Pressany pad to clear.
1. Unlatch the door and wait until the sound of
Special Functions:
circulating water stops.
2. Open the door and add the item.
Drain/Off:
When the Drain/Off pad is pressed, 1 MIN. 3. Close the door and pause briefly before
latching the door. The cycle will continue at
will appear in the display and the dishwasher the point it was interrupted.
will drain for approximately 1 minute.
To cancel a cycle without draining, press the
Drain/Off pad twice. This will immediately
turn the dishwasher off.
PAGE10