Selection Of Parameter Presettings For A Hydraulic Unit; Applications - Honeywell SDC 7-21 Installation Instructions Manual

Selection of parameter presettings for a hydraulic unit

Operation
34
5 Selection of parameter presettings for a hydraulic
unit
In the state of delivery, each controller type covers multiple
hydraulic units. Each hydraulic unit can be changed or expanded
by changing and/or adding parameters.
A hydraulic unit is selected with parameter 01 in the "Hydraulics"
menu. The corresponding inputs and outputs are assigned
automatically based on the hydraulics schematic.
This function simplifies the setting of a documented hydraulic unit
considerably.
Additional applications can be covered by setting the individual
parameters. Where necessary, the parameters are also specified
in these mounting instructions. A description of how to access
parameter settings can be found in the parameter list.
Operating in-
formation
Hydraulics
preselection
Pos: 9 /1 56-H oney well/M onta ge/Ap plikatio nen @ 1\ mod _12 085 0777 870 1_6 .doc @ 11 085

6 Applications

See chapter 10 Εφαρμογές θέρμανσης / Heating applications pg. 46
and chapter 11 Εφαρμογές τηλεθέρμανσης /
District heating applications pg. 73.
Pos: 10 / 156 -Hon eywell/ Mont age /Tec hnisch e_Da ten _Allgem ein @ 1\m od_ 120 7651 393 978 _6.d oc @ 101 15
Menu Parameter
"Hydraulics" 01
SDC
Enter
schematic, e.g.
0201
MU1H-0438GE51 R0313