Table of Contents
Advertisement
4-wIre pOwer SUppLy COrD
CONNeCTION
Choose a standard power supply cord connector:
Flanged spade connectors
7.
Prepare to connect neutral
ground wire and neutral wire.
Remove center, silver-colored terminal block screw. Remove
neutral ground wire from external ground conductor screw.
8.
Connect neutral ground wire
and neutral wire
Connect neutral ground wire and neutral wire (white or center
wire) of power supply cord under center, silver-colored
terminal block screw. Tighten screw.
9.
Connect ground wire
Connect ground wire (green or bare) of power supply cord
to external ground conductor screw. Tighten screw.
8
Ring connectors
10.
Connect remaining wires
Connect remaining wires to outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover into
slot of dryer rear panel. Secure cover with hold-down screw.
Now, go to Venting Requirements.
3-wIre pOwer SUppLy COrD
CONNeCTION
Choose a standard power supply cord connector:
Flanged spade connectors
11.
Remove center screw
Remove center, silver-colored terminal block screw.
12.
Connect neutral wire
Connect neutral wire (white or center wire) of power supply cord
to center, silver-colored screw on terminal block. Tighten screw.
Ring connectors
Advertisement
Table of Contents
