Jog Wheel - Korg nanoKONTROL Studio Owner's Manual

Buttons
Assign Type ............... [Note, Control Change, No Assign]
This parameter specifies the MIDI messages assigned to but-
tons.
Note (Note# C-1 to G9) Note messages will be transmitted. Specify the note
number to be transmitted. Up to four note numbers can
be assigned.
Control Change Control change messages will be transmitted. Specify
(CC# 0 to 127) the control change number to be transmitted.
No Assign No MIDI message will be transmitted.
MIDI Channel ............................................. [1...16, Global]
This parameter specifies which MIDI channel is used to transmit
MIDI messages. When set to "Global", MIDI messages will be
transmitted on the Global MIDI Channel, specified in the global
parameters.
Off Value ................................................................ [0...127]
This parameter specifies the value of the message that is trans-
mitted when the button is switched off.
On Value ................................................................ [0...127]
This parameter specifies the value of the message that is trans-
mitted when the button is switched on.
When "Assign Type" is set to "Note", a note-on message is
transmitted with the On Value as the velocity. When "On Value"
is set to "0", a note-on message is transmitted with "1" as the
velocity.
Button Behavior ............................. [Momentary, Toggle]
The button can be set to either of these modes:
Momentary When "Assign Type" is set to "Note", a note-on message is transmitted
when you press the Button, and a note-off message is transmitted
when you release the Button. When "Assign Type" is set to "Control
Change", a control change message with a value of 127 is transmitted
when you press the Button, and a control change message with a value
of 0 is transmitted when you release the Button.
Toggle When "Assign Type" is set to "Note", each press of the Button will
alternately send a note-on message or a note-off message. When
"Assign Type" is set to "Control Change", each press of the Button will
alternately send a control change message with a value of 127 or 0.

Jog Wheel

Jog Wheel Type ..... [Inc/Dec Button 1, Inc/Dec Button 2,
Continuous, Sign Magnitude, No Assign]
This parameter specifies the transmission of MIDI messages
when you turn the Jog Wheel.
Inc/Dec Button 1 Control change messages will be transmitted with a different CC
Inc/Dec Button 2 number depending on whether the jog dial is turned clockwise or
counterclockwise. This can be used, for example, to control the
playback location with the forward and back buttons. When set to
"Inc/Dec Button 1", a control change message with the value 127
(equivalent to turning on the button) is transmitted when you turn
the Jog Wheel. When set to "Inc/Dec Button 2", a control change
message with the value 127 (equivalent to turning on the button) or
with the value 0 (equivalent to turning off the button) is transmitted
when you turn the Jog Wheel.
Continuous Control change messages will be transmitted continuously. Turning
the Jog Wheel clockwise increases the value, and turning the Jog
Wheel counterclockwise reduces the value.
12