System Upgrade; Scan Mode Periode; Mute; Load Default - Danguard HS-200 User Manual

5. Main Menu

System Upgrade

Press the p or q button to select the menu item SYSTEM UPGRADE. In this menu, you can
update the firmware of the monitor, or the cameras.
1. Copy the firmware to an SD card or a USB stick and plug it into the monitor.
2. Select „Upgrade Firmware local" with the p or q key and confirm with OK. Now press to start
the update process button (record button). A popup message appears. Press OK to confirm
or MENU to cancel.

Scan Mode Periode

Press the p or q button to select the menu item SCAN MODE PERIODE. In this menu you can
set the interval of the video. If you have for example connected four cameras and set the monitor
to single-image display, change the camera images automatically after a certain time. You can
have an interval of 5, 10, set 15, 20 or 30 seconds.

Mute

Press the p or q button to select the menu item MUTE. In this menu you can turn on or off the
volume of the monitor.

Load Default

Press the p or q button to select the menu item LOAD DEFAULT. In this menu, the monitor can
be reset to the default setting. All the settings you have made are lost. Confirm the operation by
clicking OK, or select „Cancel" to leave the menu.

Brightness

Press the p or q button to select the menu item „BRIGHTNESS". In this menu you can adjust
the brightness of the monitor. Use the t or u keys to adjust brightness. Confirm with OK to save
and exit the menu.
12
ENGLISH
5. Main Menu

Volume

Press the p or q button to select the menu item „VOLUME". In this menu you can adjust the
volume of the monitor. Use the t or u keys to adjust the volume. Confirm with OK to save and
exit the menu.

Alarm Volume

Press the p or q button to select the menu item „ALARM VOLUME". In this menu you can adjust
the alarm volume of the monitor. Use the t or u keys to adjust the volume. Confirm with OK to
save and exit the menu.

Power Saving Mode

Press the p or q button to select the menu item „POWER SAVING MODE". In this menu you can
define an energy-saving model for the monitor. Choose between two options:
Time Interval:
Sets the monitor in a certain time in the sleep mode if at this time there is no operation on the
monitor. You can select between OFF, half a minute, 2 minutes, 5 minutes or 10 minutes.
Wake up on motion:
Select „Yes", the monitor is automatically turned on again when the camera detects motion.
Select „No", the monitor remains off until you press a button.
ENGLISH
13