Danguard HS-200 User Manual page 3

4. Operation
1. Connect the camera to the power supply. The power Indicator on the back is turned on.
2. Connect the receiver to the power supply.
3. Press the power switch on the receiver for 2s. or press the power switch
control (direct the remote control toward the receiver). The power indicator is turned on and the
power-on picture appears.
4. Pair the cameras and receiver respectively (at most four cameras can be connected at the same
time). Pairing is completed by default before delivery. If pairing is not completed, complete pairing
according to "Pairing" on page 18.
06
on the remote
ENGLISH
4. Operation
5. After successful pairing, the following real-time monitoring picture appears:
Picture display area
Time stamp
2013/11/15/09:30
Picture display area
2013/11/15/09:30
6. Press the button to switch between four display modes:
four pics
one big,
three small pics
7. Press the button to enter cyclic mode display. Five cyclic intervals are available: 5s, 10s, 15s,
20s, and 30s and can be set under "System".
Meanings of icons on the real-time monitoring picture:
Mobile hard disk inserted successfully
SD card inserted successfully
No open router
Network connection failure
Network connection successful
Picture display area
2013/11/15/09:30
Picture display area
2013/11/15/09:30
one pics
one big,
three small pics
Current camera
Recording status
Signal intensity
Camera name
Mute
ENGLISH
07