Setting The Push Notification; Operating With Ios Devices; Connect To The Network - Danguard HS-200 User Manual

6. Operating with Android devices

Setting the Push Notification

Go to the Main Menu -> System -> Network
-> Push notification. in the menu item „Enab-
le / Disable", you can set the push notification
on or off. By „minimum time interval", the time
delay of a push notification can be set.
Note:
Only if the motion detection and/or heat
detection in the menu item „Recording"
is enabled, a push notice may be served.
Click at the Android app to „push notification settings" to register an account. When motion is
detected by the camera, it sends a push notification to your phone.
Important notes:
1. Only when the receiver in the real-time state, to view the image.
2. If the Device ID was unable to get to the monitor, indicates that monitor did not normally
connect outer net, need to check your network.
3. If everything is normal, but still not in the mobile phone client to view images, please close the
client software running always in the background, please try it again.
4. The network adapter does not support hot-swappable, before open the monitor, The network
is connected with the monitor.
24
ENGLISH

7. Operating with iOS devices

Connect to the network

Insert the receiver in the pedestal, and connect
with the base power. Then connect the outer
net. Turn on the receiver.
After successful connection, go to the Main
Menu -> Network -> Network Information. In
the monitor display the following window will
be displayed.
Note:
If you want to stream the videos over the
phone network on your smartphone, you
must enable the UPnP function on your
Internet router.
Warning: uPnP is not supported by any
Internet router. Alternatively, you enter
the port that is displayed on the display
manually.
Download & Operation the App for Android devices
Check the App Store with your mobile device (eg smartphone). Search for the application
„GoCam4CH" and download it. Install the software.
Note:
The network features with iOS devices is
only in available at the IP version of the
camera system.
The monitor does not support Plug and
Play. First, plug the network adapter and the
LAN cable before you turn on the monitor.
Networ k Informatio n
Golbal IP
Loca l IP
Port
5003
Device ID
Networ k ready!
GoCam4CH
ENGLISH
25