Table of Contents
Advertisement
E L E C T R O N I C S
AUXILIARY SWITCHES — IF EQUIPPED
There can be up to five auxiliary switches located in the lower switch bank of the
instrument panel which can be used to power various electronic devices and PTO
(Power Take Off) – If Equipped. If Power Take Off is equipped, it will take the place
of the fifth Auxiliary switch. Connections to the switches are found under the hood in
the connectors attached to the auxiliary Power Distribution Center.
You have the ability to configure the functionality of the auxiliary switches via the
Electronic Vehicle Information Center (EVIC) or Driver Information Display (DID). All
switches can now be configured for setting the switch type operation to latching or
momentary, power source of either battery or ignition, and ability to hold last state
across key cycles.
NOTE:
Holding last state conditions are met when switch type is set to latching and power
source is set to ignition.
For further information on using the auxiliary switches, please refer to the Ram Body
Builders Guide by accessing www.rambodybuilder.com and choosing the appropriate
links.
158
Advertisement
Table of Contents
