Table of Contents
Advertisement
E L E C T R O N I C S
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
HomeLink
replaces up to three hand-held transmitters that operate devices such as
®
garage door openers, motorized gates, lighting or home security systems. The HomeLink
®
unit is powered by your vehicles 12 Volt battery.
The HomeLink
buttons that are located in the overhead console or sunvisor
®
designate the three different HomeLink
®
channels.
The HomeLink
®
indicator is located above the center button.
Before You Begin Programming
HomeLink®
Ensure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
For efficient programming and accurate
transmission of the radio-frequency sig-
nal, it is recommended that a new battery
be placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink
system.
®
To erase the channels, place the ignition
Universal Garage Door Opener
switch into the ON/RUN position, then
(HomeLink®) Buttons
push and hold the two outside HomeLink
®
buttons (I and III) for up to 20 seconds or
until the red indicator flashes.
NOTE:
Erasing all channels should only be performed when programming HomeLink
®
for
the first time. Do not erase channels when programming additional buttons.
If you have any problems, or require assistance, please call toll-free 1-800-355-3515
or, on the Internet at HomeLink.com for information or assistance.
152
Advertisement
Table of Contents
