Bosch PLL 5 Original Instructions Manual page 20

OBJ_BUCH-311-007.book Page 20 Tuesday, May 6, 2014 1:30 PM
20 | English
Line laser
Batteries
Weight according to
EPTA-Procedure 01/2003
Dimensions
* when using the wall holder 1; under unfavourable conditions such as intense sun irra-
diation, the working range is smaller
** when the measuring tool is positioned correctly (see "Positioning the Measuring Tool
(see figure B)", page 21)
The measuring tool can be clearly identified with the serial number 15 on the type plate.
Assembly
Inserting/Replacing the Batteries (see figure A)
Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid 11, press the latch 10 in the direction of the arrow
and remove the battery lid.
Place the battery-recovery ribbon under the first battery being inserted.
Insert the supplied batteries in the sequence shown in the figure, paying
attention to the correct polarity.
Always replace all batteries at the same time. Only use batteries from one
brand and with the identical capacity.
 Remove the batteries from the measuring tool when not using it
for extended periods. When storing for extended periods, the batter-
ies can corrode and self-discharge.
Operation
Initial Operation
 Protect the measuring tool against moisture and direct sun light.
 Do not subject the measuring tool to extreme temperatures or var-
iations in temperature. As an example, do not leave it in vehicles for
longer periods. In case of large variations in temperature, allow the
measuring tool to adjust to the ambient temperature before putting it
into operation.
1 609 92A 0JK | (6.5.14)
PLL 5
2 x 1.5 V LR03 (AAA)
0.12 kg
142 x 27 x 30 mm
Bosch Power Tools