Installing A Microsdhc™ Card; Charging The Battery; Extending The Battery Life; Powering Your Phone On/Off - Zte AVID 828 User Manual

GETTING STARTED
INSTALLING A microSDHC™ CARD
The microSDHC card can be installed and removed while the phone is powered
on . Unmount the microSDHC card before removing or replacing it .
1 . Remove the back cover .
2 . Hold your microSDHC card with the metal contacts
facing down and slide it into the card slot .
Note: Some applications may require a microSDHC
card to work normally or may store certain data on it .
Therefore, it is recommended that you keep a microSDHC
card installed and not remove or replace it randomly .
3 . Press the back cover gently back into place until you hear a click .

CHARGING THE BATTERY

Your phone's battery should have enough power for the phone to turn on,
find a signal, and make a few calls . You should fully charge the battery as
soon as possible .
If the battery is low, there will be a pop-up message on the
screen . As you charge your phone, the screen will tell you
the exact battery level each time you wake up your phone .
Warning! Use only ZTE-approved chargers and cables . The
use of unapproved accessories could damage your phone
or cause the battery to explode .
1 . Connect the adapter to the charging port .
8
2 . Connect the charger to a standard AC wall outlet . If the phone is on, you'll
see a charging icon, such as
3 . Disconnect the charger when the battery is fully charged .
Note: If the battery is extremely low, you may be unable to power on the
phone even when it is being charged . In this case, try again after charging
the phone for at least 20 minutes . Contact customer service if you still cannot
power on the phone after prolonged charging .

EXTENDING THE BATTERY LIFE

Active applications, screen brightness levels, Bluetooth , and GPS functionality
can drain your battery . You can follow the helpful tips below to conserve your
battery power:
• Reduce the screen backlight time .
• Lower the screen brightness .
• Turn auto-sync and Bluetooth off when not in use .
• Disable the GPS function when not in use . Most applications using this
function will periodically ping the GPS satellites for your current location;
each ping drains your battery .

POWERING YOUR PHONE ON/OFF

• Press and hold the Power Key to power on your phone .
• To turn it off, press and hold the Power Key to open the options menu . Tap
Power off .
GETTING STARTED
or , appear in the Status Bar .
9