Page 1
AeraMax Pro AM II ® Air Purifier | Purificateur d’air | Purificador de aire PLEASE READ THESE INSTRUCTIONS BEFORE USE. DO NOT DISCARD: KEEP FOR FUTURE REFERENCE. VEUILLEZ LIRE CES INSTRUCTIONS AVANT D’UTILISER L’APPAREIL. NE PAS JETER : CONSERVER AFI N DE CONSULTER LES DIRECTIVES ULTÉRI- EUREMENT, EN CAS DE BESOIN.
LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the AeraMax ® PRO air quality control system (the “Product”) to be free of defects in material and workmanship for 3 years from date of purchase. In the event that the Product is installed into new construction, the warranty period shall commence on the date of the occupancy permit or one year after the date of purchase, whichever is earlier.
• Wall mount screws (4) and installation bracket PRODUCT SPECIFICATIONS AeraMax ® PRO AM II Dimensions (H x W x D) 22.3 x 13.7 x 4 inches / 56.5 x 34.9 x 10.2 cm Weight of System (including filters) 10.6 lbs. / 4.81 kg Power Requirements 120 volt, 60 Hz, 1.37 amp...
DISPLAY PANEL CARBON HEPA NOTE: after the unit is turned on the “AQ” light will flash for a few minutes while the system self-calibrates. AIR QUALITY SENSOR – This indicator monitors the air quality and PlasmaTRUE™ TECHNOLOGY – Creates an ionized field to help adjusts the fan speed to keep your air purified.
OPERATION The air purifier continuously works in automatic mode; The air purifier will operate through the 5 levels of speeds in order to clean room of contaminents. Once air is cleaned, and no sensors are activated, the unit lowers to energy saving mode to reduce energy consumption and extend the life of the filters. When Manual Mode is selected the Manual indicator on the control panel will be blue.
Page 6
7. Install the filters in the unit. Note: The “AeraMax Pro Certified Filter Sticker” on the filter must align with the identical sticker found on the unit. If the filter is not installed properly, the unit will not power on.
Amber flashing = 90% filter wear (recommendation to order new filters) Red = 100% filter wear (replace with new filters) Do not wash and reuse any of the filters – they will not work effectively. Only use AeraMax ® PRO brand replacement filters as units will not function using any other replacements.
Need help?
Do you have a question about the Pro AM II and is the answer not in the manual?
Questions and answers