Setting up the Scanner
Power turn-on sequence
1
Turn on the power of the scanner.
• Connect the power cord to the AC adaptor.
• Connect the AC adaptor to the scanner.
• Plug into an AC outlet.
• Push the power switch.
• The LED (Green) will blink for about 30
seconds and then it will become steady.
Note:
• Install the software first.
About LED
The status of the scanner can be established by the condition of the two LED indicators shown in the table below:
LED (Green)
ON
Blink (Slow)
ON
Blink (Slow)
ON
Blink (Fast)
*1
It will take about 30 seconds to initialize the scanner.
12
Power switch (
Power cord
LED (Green)
LED (Red)
LED (Red)
OFF
Ready
OFF
Sleep
Blink (Slow)
Caution
Blink (Slow)
Caution/Sleep
ON
Error
OFF
Warming up
)
AC adaptor
Ready
Error
Start / Stop
Status
*1
USB cable