Email Sending Triggered By Alarm - Hills NVC-BM1 User Manual

2. Check the checkbox to enable the UPnP™ function.
The name of the device when detected online can be edited.

5.3.9 Email Sending Triggered by Alarm

Purpose:
The system can be configured to send an Email notification to all designated receivers
if an alarm event is detected, e.g., motion detection event, video loss, video tampering,
etc.
Before you start:
Please configure the DNS Server settings under Basic Configuration > Network >
TCP/IP or Advanced Configuration > Network > TCP/IP before using the Email
function.
Steps:
1. Enter the TCP/IP Settings
TCP/IP or Configuration > Advanced Configuration > Network > TCP/IP) to
set the IPv4 Address, IPv4 Subnet Mask, IPv4 Default Gateway and the Preferred
DNS Server.
Note: Please refer to Section 6.3.1 Configuring TCP/IP Settings for detailed
information.
2. Enter the Email Settings interface:
Configuration > Advanced Configuration > Network > Email
Figure 5-16 Configure UPnP Settings
Configuration > Basic Configuration > Network >
(
33