Voltage Trigger; Speaker Output - Nuvo NV-P2100 Owner's Manual

Voltage Trigger

This input is designed for a mono 1/8" plug to accept a
trigger voltage coming in from an external source.
Fig. 4.
Fig. 4
CONTROL CONTROL
POWER VOLTAGE
MODE TRIGGER
ON/OFF SWITCH
3-30 VOLTS
AC OR DC
AUDIO AC/DC
Any voltage ranging from 3 to 30 volts AC or DC will
cause the amplifier to turn on when the POWER MODE
switch (fig. 3C) is in the AC/DC mode.
Unit On
This output provides a constant 12 volts DC when the
amplifier is powered on. This is useful for powering on
external equipment with the P2100 Fig 5.
Fig. 5
CONTROL CONTROL
POWER VOLTAGE
MODE TRIGGER
ON/OFF SWITCH 3-30 VOLTS
AUDIO AC/DC AC OR DC
UNIT
ON
+12VDC
100mA
UNIT
ON
+12VDC
100mA

Speaker Output

The P2100 provides 100 watts of output power per
channel at 4 ohms. It uses a modular plug that will
accept up to 14 gage, four conductor, speaker wire.
Stranded Four conductor sixteen gage wire is recom-
mended Fig 6.
Fig. 6
SPEAKER
OUTPUT POWER
8 OHM: 70W X 2
4 OHM: 100W X 2
The NV-P2100 amplifier is designed to run at a maxi-
mum load of 4 ohms. Prolonged operation at less than
4 ohms could cause the amplifier to overheat and do
damage to its internal components. Overheating the
amplifier due to an excessive load will void the war-
ranty.
9