Main Menu - L-Acoustics LA4X User Manual

4.3.2

Main menu

The main menu gives access to the pages listed in the following table. Refer to the corresponding sections for detailed
instructions.
LA NETWORK MANAGER software
All parameters in each amplified controller can also be set from LA NETWORK MANAGER software (refer to
the LA NETWORK MANAGER video tutorial).
Page
LOAD PRESET USER
LOAD PRESET FACTORY
STORE PRESET
DELETE PRESET
PRESET PARAMETERS
CLEAR GROUP PARAMS
INPUT SETTINGS
MONITORING & INFO
OPTIONS
To enter a page, follow these steps (see also Figure 23):
1. Press and release the encoder wheel.
2. Turn the encoder wheel clockwise or counterclockwise to select a page.
3. Press the OK key or the encoder wheel to enter this page or press the ESC key to return to the main screen.
On the LCD screen, two types of arrow cursors indicate how to navigate
through the menus, see Figure 23:
Position cursors (on the left)
Start of a menu. Other functionalities can be displayed turning the

encoder wheel clockwise.
 Middle of a menu. Other functionalities can be displayed turning the
encoder wheel clockwise or counterclockwise.
 End of a menu. Other functionalities can be displayed turning the
encoder wheel counterclockwise.
Selection cursors (on the right)
Another menu level or function can be accessed pressing the OK key

or the encoder wheel.
Press the ESC key to return to the previous menu.
No additional menu level or function exist.

Turn the encoder wheel to access another menu or press the ESC
key to return to the previous menu.
LA4X_UM_EN_4.0
Table 5: Main menu description
Functionalities
load a user preset (memories 1-10)
load a factory preset (memories 11-199)
save the current preset (including the current settings) as a user preset
(memories 1-10)
delete a user preset (memories 1-10)
set the gain, delay, polarity, and input selection parameters
remove the group parameters defined in LA NETWORK MANAGER
software (names, gains, delays and Contour EQs)
set the input mode, fallback mode and AES/EBU gain
display real-time measured values: RMS output voltage and output
temperature (in percentage of the maximum values)
display the firmware and factory preset library versions
display the controller's MAC address
set the controller's IP address
set the delay unit, LCD screen contrast and light mode
reset all parameters to factory defaults
w w w . l - a c o u s t i c s . c o m
Section
4.4
4.5
4.6
4.7
4.8
4.9
4.10
4.11
Figure 23: Main menu
27