Set Sleep Timer; Troubleshooting - Kruger&Matz KM1663 Owner's Manual

Owner's manual
5. Press / button on the front panel or remote control to set minute. Press TIMER
button to confirm.
6. Press VOL +/– button to adjust volume, then press TIMER button to confirm. A clock
icon appears on the display.
Activate/deactivate alarm timer
In standby mode, press TIMER button repeatedly to activate/deactivate timer.
• If timer is activated, the icon
• If timer is deactivated, the icon
Note:
• The alarm timer is not available when the source is set as "AUDIO IN/AUX IN".
• If the USB source is selected but no USB connected, the unit switches to FM
automatically.

SET SLEEP TIMER

This unit can switch to standby mode automatically after a set period.
• When the unit is turned on, press SLEEP button repeatedly to select a preset period
(in minutes).
• When the sleep timer is activated, SLEEP icon is displayed.
• To deactivate the sleep timer, press SLEEP button repeatedly until [OFF] (sleep off)
appears.

TROUBLESHOOTING

If you are having a problem with your system, check this list for a possible solution before
calling for service. If you can not solve the problem from the hints give here, or the system
has been physically damaged, call a qualified person, such as your dealer, for service.
No power
• Ensure that the AC power plug of the unit is
connected properly.
• Ensure that there is power at the AC outlet.
Timer does not work
• Set the clock correctly.
• Switch on the timer.
Remote control does not work
• Reduce the distance between the remote
control and the unit.
• Insert the battery with its polarities (+/-
signs) aligned as indicated.
• Replace the battery.
• Aim the remote control directly at the
sensor on the front of the unit.
is displayed.
disappears on the display.
Poor radio reception
• Increase the distance between the unit and
your TV or VCR.
• Fully extend and adjust the FM antenna.
Bluetooth device cannot connect with
KM1663
• The device does not support the profiles
required for the system.
• The Bluetooth function of the device is not
enabled.
• The system is not in the pairing mode.
• The system is already connected with
another Bluetooth device.
• Disconnect that device or all other
connected devices and then try again.
27