Resetting The Ap-7131 Password - Motorola AP-7131 Release Notes

7. Click 'Apply'.
8. Click the 'Perform Update' button to initiate the update. Upon confirming the
firmware update, the AP reboots and completes the update. This step may
take several minutes.
9. After the AP reboots, clear the browser cache and return to the 'Firmware
Update' screen. Check the Status field to verify whether the firmware update
was successful.

Resetting the AP-7131 Password

The AP-7131 Command Line Interface (CLI) enables users who forget their password
to reset it to the factory default ('motorola'). To reset the AP-7131 password:
Connect one end of the null modem serial cable to the AP-7131's console connector.
(Use cable p/n 25-97593-01R for the AP-7131). Attach the other end of the null
modem serial cable to the serial port of a PC running HyperTerminal or a similar
emulation program.
1. Set the HyperTerminal program to use 19200 baud, 8 data bits, 1 stop bit, no
parity, no flow control and auto-detect for terminal emulation.
2. Press <ESC> or <Enter> to access the AP-7131 CLI. A serial connection has
now been established and the user should be able to view the serial
connection window.
3. Reset the AP-7131. An AP-7131 can be reset by removing and re-inserting
the LAN cable (if you are not using power supply) or removing and re-
inserting the power cable. As the AP-7131 is re-booting, a "Press esc key to
run boot firmware" message displays.
4. Quickly press <ESC>. If the <ESC> key is pressed within three seconds a
boot> prompt displays.