Strong SRT 6010 User Manual page 38

UM 6005-15 ENG 1/26/06
Over Air Download (OAD)
Select this option in order to update your receiver with the latest software version.
The receiver will check availability of the software update on air and load the latest software, if
available. You will be asked to confirm update. Do not switch power off and do not disconnect the
receiver from the aerial during update process.
Availability of the software update is subject of local broadcast condition and may not work in all
countries. Contact your vendor to find out more about this function.
Update through PC to STB
1. Connect Computer to receiver (receiver must be power off) with a 9-pin cross cable (two females)
2. The computer will follow the steps below:
Start -> Programs -> Accessories -> Communications -> Hyper terminal
Then choose "COM1" or "COM2" according to which port you are using in the computer and port
setting as follows:
Bits per Second:
Data bits:
Parity:
Stop bits:
Flow Control:
3. In Hyper Terminal menu select "transfer" item and then press "send file" item. Select the file
with the new software (*.UPD) you want to download and choose the protocol
"1K Xmodem". Finally press ok and a download menu will appear in the computer screen.
Power on the receiver, then the download process will begin.
4. After about 2.5 minutes, the message "OK, Reset" will appear on the computer on Hyper
Terminal window, which means the download has completed successfully.
5. Power off the receiver and then unplug the RS 232 interface.
*Note: INCORRECT OPERATION MAY CAUSE UNREPAIRABLE DAMAGE TO THE RECEIVER.
1. DO NOT POWER OFF THE RECEIVER DURING THE PROCESS OF DOWNLOAD.
2. DO NOT PLUG IN OR UNPLUG THE RS232 INTERFACE WHEN RECEIVER IS POWERED ON.
38
4:18 PM Page 38
115200
8
None
1
None
PART 1 English