Operation - Kärcher HD 10/16-4 Cage Manual

 Insert the detergent suction hose into
an external detergent container.
 Fill/replace empty detergent container.
Dearating the appliance
 Remove exchange nozzle.
 Switch on the appliance and let it run
until the water exiting from the spray
pipe is bubble-free.
 Switch off the appliance and fit the noz-
zle again.

Operation

Safety instructions
DANGER
– Do not use the appliance when there
are other persons around unless they
are also wearing protective clothing.
– The jet must not be directed by the user
at him/herself or at other persons to
clean clothing or footwear.
– Do not drive over the main cable or the
high pressure hose.
WARNING
The water jet that is emitted from the high-
pressure nozzle results in a repulsion pow-
er acting on the hand spray gun. Make sure
that you have a firm footing and hold the
trigger gun and the spray lance with both
hands.
Turning on the Appliance
 Open tap.
 Plug in the mains plug.
 Set the appliance switch to "I".
 Unlock the hand wheel on the hand
spray gun by turning it and pull lever.
Detergent dosing
1 Lock nut
2 Lock screw
 Open the safety screw.
 Turn the knurled nut of the detergent
nozzle in an anti-clockwise direction un-
til it stops. Detergent is suctioned with
low pressure.
 Slightly tighten the safety screw.
– Setting the detergent concentration
 Pull the detergent suction hose out of
the detergent container.
 Turn filter on the detergent suction hose
in order to dispense the detergent.
Nozzle change
The serial exchange nozzle is combined in
a power and a round jet nozzle.
– Here, you can switch between the pow-
er and the round jet nozzle by tilting the
spray lance slightly with the hand spray
gun closed. If necessary, if the switch-
ing does not function properly, tap light-
ly on the exchange nozzle.
– The water will emerge via the nozzle,
which has been elevated by opening
the hand spray gun.
– With the hand spray gun open, the se-
lected nozzle will always remain open,
regardless of the position of the ex-
change nozzle.
Power nozzle (two flat connection)
– 25° spray angle
– Carrying out the most common cleaning
tasks
– 5
EN 19