Audio Setup; Usb Operation - Numark M6 Quick Start Manual

USB OPERATION

The M6 USB is equipped with a USB port which allows you to play content from your computer through the
mixer, or record audio from the mixer directly into your favorite software application. The USB interface on
your mixer works with your computer just like a standard USB sound card. In addition, the USB interface is
class-compliant, so there are no special drivers or software to install; simply connect a USB cable from the
USB port to your computer and you are ready to go!

AUDIO SETUP

The M6 USB is a class-compliant device that can be used with
any digital audio workstation or recording software that
supports USB audio. To enable your M6 USB to send and
receive audio to and from your computer, follow the
instructions below for your computer's operating system:
WINDOWS 7:
1. Use the included cable to connect the M6 USB to your
computer.
2. Go to Start Menu
Sound Sound.
3. Click the Playback tab and select USB Audio Codec*
as the default device.
4. Click the Recording tab and select USB Audio Codec*
as the default device.
5. Click Properties in the lower right-hand corner.
6. In the new window, click the Advanced tab and select 2-
channel, 16-bit, 44100 Hz (CD Quality) as the default
format.
7. Uncheck both boxes under Exclusive Mode.
8. Click the Levels tab and set the slider to "4."
9. Click OK to close the Properties window.
10. Click OK to close the Sound control panel.
WINDOWS VISTA:
1. Use the included cable to connect the M6 USB to your
computer.
2. Go to Start Menu
View, and the Sound Control Panel should become available.)
3. Click the Playback tab and select USB Audio Codec* as the default device.
4. Click the Recording tab and select USB Audio Codec* as the default device.
5. Click Properties in the lower right-hand corner.
6. In the new window, click the Advanced tab and select 2-channel, 16-bit, 44100 Hz (CD Quality) as
the default format.
7. Uncheck both boxes under Exclusive Mode.
8. Click OK to close the Properties window.
9. Click OK to close the Sound control panel.
WINDOWS XP:
1. Use the included cable to connect the M6 USB to your computer.
2. Go to Start Menu
3. Click the Audio tab.
4. Under Sound Playback and Sound Recording, select USB Audio Codec* as the default device.
5. Click OK.
MAC:
1. Use the included cable to connect the M6 USB to your computer.
2. Go to Applications
3. In the Audio Devices tab under System Settings, select USB Audio Codec* as your Default Input
and Default Output.
4. Close the window.
Control Panel Hardware and
Control Panel Sound. (If you don't see Sound, select Switch to Classic
Control Panel Sounds and Audio Devices.
Utilities Audio MIDI Setup.
Be sure your audio software program is
set up to receive audio via the M6 USB.
This can usually be done in your
software's "Preferences" or "Device
Setup." Please consult your software
manual for more information.
* If you have other USB audio devices
connected to your computer, which may
have identical names, you may need to
try selecting each one until the M6 USB
is recognized.
If you experience too much latency
after adjusting your software latency
settings,
ASIO4ALL (Audio Stream Input/Output)
driver for PC at www.asio4all.com.
ASIO drivers generally perform better
and with lower latency since they create
a more
between audio devices and software.
6
we recommend the
efficient communication
free