Button Lock - Panasonic TH-43LFE8U Operating Instructions Manual

Button lock

Limits operation of the buttons on the unit.
[Off]: All the buttons on main unit can
be used.
[MENU&ENTER]: Locks <MENU (Unit)> and
<ENTER (Unit)> buttons.
[On]: All button operations except for the
power switch are disabled.
■
To set [Button lock]
Set with the buttons on the unit.
[Off]:
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)>.
[MENU&ENTER]:
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <INPUT (Unit)> for 4 times.
Press <ENTER (Unit)>.
[On]:
Press <- (Unit)> for 4 times.
Press <ENTER (Unit)> for 4 times.
Press <+ (Unit)> for 4 times.
Press <ENTER (Unit)>.
Controller user level
Limits operation of the buttons on the remote control.
[Off]: You can use all of the buttons on the remote
control.
[User1]: You can only use standby (ON/OFF) button,
<INPUT>, <RECALL>, <MUTE>, <VOL +>
and <VOL -> buttons on the remote control.
[User2]: You can only use standby (ON/OFF) button
on the remote control.
[User3]: Locks all the buttons on the remote control.
PC auto setting
Sets the operational mode of the automatic position
adjustment in the [Position] menu.
[Off]: Automatic position adjustment starts when
<AUTO SETUP> is pressed on the remote
control or automatic position adjustment is
executed from the [Position] menu.
[On]: Other than remote control or menu
operation, automatic position adjustment
starts:
When the display power is turned ON.
When the input signal is switched.
Off-timer function
Enables / disables Off timer function.
[Enable]: Enables the [Off-timer function].
[Disable]: Disables the [Off-timer function].
Note
●
When [Disable] is set, the Off-timer is cancelled.
Initial power mode
Sets the power mode of the unit for when the power
recovers from failure or after plugging off and in again.
[Normal]: Power returns in as the same state as
before the power interruption.
[Standby]: Power returns in standby mode.
(Power Indicator: red/orange)
[On]: Power returns in power On.
(Power Indicator: green)
Note
● When using multiple displays, [Standby] is preferred
to be set in order to reduce a power load.
Display ID
Sets ID number when controlling the Display with
[Controller ID function] and [Serial ID function].
0 - 100 (Standard value: 0)
Controller ID function
Enables/Disables the ID remote control function.
[Off]: Disables the ID remote control function. (Can
be operated as normal remote control.)
[On]: Enables the ID remote control function.
Effective on switching to [On].
Note
●
To use the ID remote control function, setting ID
numbers both for the remote control and for the
display unit is required.
For ID number setting for the remote control
and display unit, see page 73 and [Display ID]
respectively.
61
English