Starting / Ending Media Player; Resume Play Function - Panasonic TH-43LFE8U Operating Instructions Manual

Note
● Set [Network control] of all displays to [On]. (see page
55)
● Depending on the network environment,
synchronization may be largely lost.
● Do not connect other devices to prevent network
traffic jam.
●
With a router put in between, you cannot set up
connection. Use them within the same subnet.
●
Do not use wireless LAN for connection since
playback may not be performed normally.

Starting / ending Media Player

■
For Single Media Player
Start
1. Insert USB memory for Media Player.
Note
● Depending on the type of a USB memory
device, it may come in contact with the
periphery such as a back cover, and cannot be
attached. Use a commercially sold extension
cable, or use a small type of a USB memory
device connectable to this unit.
USB
terminal
2. Run a USB memory contents check.
3. Change INPUT to USB.
Ending
Change INPUT to other than USB.
■
After Media Player ends, the file to be resumed when
resuming playing varies depending on the setting of
[USB media player settings] - [Resume play].
When set to [On]:
When set to [Off]:
●
USB
memory
For Multi Media Player
Start
1. Connect several units with LAN cables.
(see page 34 "Example of setting up LAN
connection and IP address / Subnet mask")
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on
each Display.
4. Change INPUT for Slave to [USB].
5. Change INPUT for Master to [USB].
Ending
Change INPUT for Master to other than [USB]

Resume Play function

The file played prior to the end of Media Player starts
playing from the beginning.
Play starts from the beginning of the first file of the
scenario.
Note
The resume play function is retained until the unit is
turned off or the USB memory device is taken out.
35
English