Leica S Instructions Manual page 16

EN Removal
1. Push the ejection slide inwards.
• The slide is then pushed out slightly.
2. Press the slide inwards again.
• The card is then pushed slightly out of the slot.
3. Pull out the card.
SD / SDHC / SDXC cards
Insertion
Push the card completely into the slot with the contacts facing to the
rear and with the beveled corner facing upwards against the spring
pressure until it engages audibly.
click
12
Important:
Ensure that no SD/SDHC/SDXC card is pushed into the CF card slot as
it might not be possible to remove it again!
Removal
1. Press the card further into the slot.
• The card is released and pushed slightly out of the slot.
2. Pull out the card.
1
2
Close cover
Close the cover and push forward until it engages.
Displays
Memory card faults are indicated by diff erent messages in the viewfi nder,
monitor and top panel display.
Notes:
• If the memory cards cannot be inserted, check that they are aligned
correctly.
• The range of memory cards available is too large for Leica Camera AG
to be able to completely test all available types for compatibility and
quality. Although using other card types is not likely to damage the
camera or the card, some "no name" cards do not comply with the
memory card standards, and Leica Camera AG is unable to provide any
guarantee that they will function correctly.
• Do not remove either a memory card or the battery as long as the red
LED at the bottom right next to the monitor is fl ashing, indicating
picture recording and/or data saving to the card(s). Otherwise the
unsaved (or not completely saved) picture data may be lost.
• The Leica S off ers diff erent variants for the storage of picture data.
Further information on this topic can be found under "Storage of
picture data / memory card management".
• As electromagnetic fi elds, electrostatic charges, and defects in the
camera or the card(s) can lead to damage or loss of the data on the
1
memory card(s), we recommend that you also transfer the data to a
computer and save it there.
• For the same reason we also recommend that the cards are always
2 stored in an antistatic case.
• The proper function of the camera cannot be guaranteed if WiFi cards
are used.
• SD, SDHC, and SDXC memory cards have a write protection switch,
which can be used to prevent unintentional storage and deletion of
pictures. This switch takes the form of a slider on the non-beveled side
of the card; in the lower position, marked LOCK, the data is protected.
• Memory cards with a capacity of less than 1 GB cannot be used.