General Precautions; Installation Notes - Perlick HD24 SERIES Installation And Operation Instructions Manual

Table of Contents

Advertisement

18" SHALLOW-DEPTH SERIES
Operation/Installation Manual

GENERAL PRECAUTIONS

DANGER
1. Risk of child entrapment. Before you throw
away your old unit, take off the doors and
leave shelves in place so children may not
easily climb inside.
2. Altering or cutting of the power cord, or
removal of the power plug, or direct wiring
can cause serious injury, fire and/or loss
of property and/or life and will void the
warranty.
WARNING
1. Never
attempt
maintenance on the unit until the electricity
has been disconnected.
2. The anti-tip kit must be installed on this unit
before it is used. Never use the shelves or
doors as steps or to support more than they
are designed to support.
INSTALLATION INSTRUCTIONS
GENERAL
1. All electrical instructions assume that outlet is
located 4-10 inches from the floor.
2. Floor must be level in area of installation. Leg
levelers are used for fine-tune adjustment only
and should not be used to compensate for floor
differences exceeding 1/2".
3. Install the anti-tip kit on the unit (see page 5 or
7.)
4. When moving unit into position, take care to
protect floor surface with cardboard, rugs, etc
(see page 4).
5. Never attempt to move unit without aid of at
least one other person.
6. Always secure doors shut prior to moving the
unit.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice
Form No. Z2325
to
repair
or
perform
CAUTION
1. Do not lift unit by shelves or door handle.
2. Failure to clean the condenser every three
months can cause the unit to malfunction.
This could void the warranty.
3. Never install the unit behind closed doors
(ie; closets, small pantries, etc). Be sure
front louvered toe plate is free of obstruction.
Obstructing free air flow can cause unit to
malfunction and may void the warranty.
4. Use only Perlick replacement parts. Use of
non-Perlick parts can damage the unit, and
may void the warranty.
MINIMUM FINISHED ROUGH OPENING
REQUIREMENTS
1. Height:
32-1/8"
2. Depth:
18-1/4"
3. Width:
24"
2

Advertisement

Table of Contents
loading

Table of Contents