[Video 2] Tab - Sony HVO-500MD Instructions For Use Manual

[Duration]
Select the duration for which captured still images are
displayed.
The default setting is [3 sec].
[Position]
Select the position in which captured still images are
displayed.
The default setting is [Left].
The four most recent still images are displayed when
[Top] or [Bottom] is selected, and the three most
recent still images are displayed when [Left] or [Right]
is selected.
[Monitor]
Select the monitor mode.
The default setting is [Normal].
Tip
If the connected monitor is in full mode, the left and
right edges of the still images displayed for the auto
live function may be cropped. In such cases, set
[Monitor] to [Normal].
3
When you finish configuration, use the V , v , B , and b
buttons to select [Apply], and press the ENTER
button.
The [Video 1] tab appears again.

[Video 2] Tab

Configure recording settings.
1
Use the B and b buttons to select the [Video 2] tab.
2
Configure each setting.
Select an item using the V and v buttons, and press the
ENTER button to display the setting screen for that
item.
[Input Detect Duration]
Select from 0 to 3 seconds for the duration for which
input signals are detected.
The default setting is [3 sec].
Tip
Image distortion may occur if a duration of 2 seconds
or less is selected.
[DVI Input Range]
Select between limited and full range for the range
mode during DVI input.
The tonal range for [Limited Range] is 16 to 235, and
the tonal range for [Full Range] is 0 to 255.
The default setting is [Full Range].
[Automatic Pause]
Select whether to automatically pause recording when
there is no input signal.
The default setting is [Not Used].
If you select [Use], recording will pause if there is no
input signal for 10 minutes.
[HPD sink interlock]
Select whether to link the HPD (hot plug detect) sink
of the device connected to the HDMI IN connector to
the source device.
The default setting is [Use].
Note
If the sink device is disconnected or turned off while
recording is in progress, the recording may be
interrupted accordingly.
3
To configure settings in other tabs, use the V , v , B ,
and b buttons to select a tab.
If you are finished configuring [Function Settings],
use the V , v , B , and b buttons to select [Apply], and
press the ENTER button to save the configurations.
75
Function Settings