Ryobi CMD-1202 User Manual page 15

GB
F D
OPERATION
ELECTRIC BRAKE
This drill has an electric brake. When the trigger switch is
released, the chuck stops turning. When the brake is
functioning properly, sparks will be visible through the
vent slots on the housing. This is normal and is the action
of the brake.
ADJUSTING THE SPEED
See Figure 8.
Follow these steps to adjust the speed.
For high speed: Slide the two-speed gear train switch
■
to "2."
For low speed: Slide the two-speed gear train switch
■
to "1."
Note: If you have difficulty changing from one gear
range to the other, turn the chuck by hand until the
gears engage.
CAUTION
To prevent gear damage, always allow chuck to
come to a complete stop before changing the
speed or the direction of rotation.
KEYLESS CHUCK
See Figure 7.
Your drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the
chuck jaws. Rotate the chuck with your hand. Rotate the
chuck body with your other hand. The arrows on the
chuck indicate which direction to rotate the chuck body in
order to LOCK (tighten) or UNLOCK (release) the drill bit.
WARNING
Do not hold chuck body with one hand and use
power of the drill to tighten chuck jaws on drill bit.
Chuck body could slip in your hand or your hand
could slip and come in contact with rotating drill bit.
This could cause an accident resulting in serious
personal injury.
BATTERY INDICATOR
The display is for guidance only. Deviations are possible for
extreme applications. See Figure 10 for display indication of
estimated battery remaining capacity. It will be turned on
when the button is pressed, and will be turned off when the
button is released
Note: Indicator is for reference only and can vary according
to ambience and application.
E I P NL S DK N FIN
English
MAINTENANCE
WARNING
When servicing, use only identical replacement
parts. Use of any other part may create a hazard
or cause product damage.
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil,
grease, etc.
WARNING
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.
come in contact with plastic parts. They contain
chemicals that can damage, weaken or
destroy plastic.
Do not abuse power tools. Abusive practices can damage
tool as well as workpiece.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste. The machine, accessories and packaging
should be sorted for en-vironmental-friendly
recycling.
11
GR H CZ RUS RO PL TR