Blodgett BCX-14G Installation Operation & Maintenance page 29

USING THE USB PORT
1. With the power on, remove the cover of the USB port
(23) and insert the USB drive.
2. Press the MAINTENANCE KEY (19).
3. Turn the dial to highlight MANAGER PROGRAM.
Press the center of the dial to select.
4. Turn the dial to highlight either COPY RECIPE FROM
USB or COPY RECIPE TO USB, then press the cen-
ter of the dial to select.
5. When the transfer is complete, press any key to re-
turn to the menu.
6. Turn the dial to highlight EXIT. Press the center of
the dial to select. The display returns to the previous
menu.
7. Turn the dial to highlight EXIT. Press the center of the
dial to select.
MANAGER PROGRAMMING
Entering the Manager Program Mode
1. Press the MAINTENANCE KEY (19). If the control
is password protected, the display reads ENTER
CODE. Use the alpha/numeric keypad to enter the
manager passcode 3124, then press the center of the
dial to enter the program mode.
2. Turn the dial to highlight OVEN SETUP. Press the
center of the dial to select the product.
Programming Auto Start
NOTE: The Auto Start function enables the oven to turn
on at a programmed time of day and preheat to
a programmed temperature.
1. Turn the dial to highlight AUTO START. Press the
center of the dial to select.
2. Turn the dial to select either ON or OFF. Press the
center of the dial to select.
If ON is selected, the display reads AUTO START 24
HOUR TIME 00:00. Turn the dial to enter the time you
would like the oven to begin preheating. Press the
center of the dial to select.
The display reads AUTO START TEMP XXX. Turn
the dial to enter the desired preheat temperature.
Press the center of the dial to select.
MenuSelect™ Control for Models BCX-14 and BX-14
PROGRAMMING OVEN SETUP
These menus allow the manager to set up basic oven
functions
1. Turn the dial to highlight OVEN SETUP. Press the
2. Turn the dial to highlight MANAGER PROGRAM.
3. Turn the dial to highlight the oven function you with to
25
Operation
center of the dial to select.
Press the center of the dial to select.
change. Press the center of the dial to select. Choose
from the following functions:
Recipe Password - Select YES or NO to enable
password protection on recipe programming. If YES
is selected the passcode 3124 must be entered to
change recipe programming.
Temp Unit - Select either degrees F or C.
Cool Down Temp - Select the set temperature for
the oven to achieve in Cool Down mode
Temp Disp Rate - Set the rate, in seconds, at which
the display switches between actual and setpoint
temperature
Input Rsp Time - Set the length of time allowed to in-
put each variable when programming recipes before
control automatically exits out
Setback Time - When not used for a period of time,
the oven temperature will automatically reduce to
conserve energy. This variable sets the length of time
the oven remains at the idle temperature before be-
ing lowered.
Ready Beep - Select either ON or OFF. This is the au-
dible alarm that sounds when the oven has reached
the set temperature.
Cook Done Beep - Select either ON or OFF. This is
the audible alarm that sounds when the product cook
time has expired.
Cook Cool Fan - Select either YES or NO. This func-
tion allows the control to display OPEN OVEN DOOR
when you are attempting to lower the set temperature
of the oven.
Restore Manual SE - Select either YES or NO. This
variable enables the oven to remember the last set-
tings used for manual cooking.
NOTE: The following apply to BCX models only.
Boiler Set Temp Preheat - Select the temperature in
the boiler when it is in stand by
Boiler Set Temp Cook - Select the temperature in
the boiler when steam is being produced