Projecting An Image (Basic Operation); Turning On The Projector - NEC NP2000 User Manual

3. Projecting an Image (Basic Operation)

This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and a POWER (ON/STAND BY) button (POWER ON and OFF on the
remote control).
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off ( )
position. Failure to do so may cause damage to the projector.
• The projector has a feature to prevent itself from being used by unauthorized individuals. To use this feature, register a keyword.
( → page 45)
1. Remove the lens cap.
• Do not try to remove the lens cap by pulling on the string.
Doing so can cause damage.
2. To turn on the main power to the projector, press the
Main Power switch to the on position ( I ).
• The projector will go into standby mode. When in standby
mode, the POWER indicator will light orange and the
STATUS indicator will light green.
3. After making sure that the projector is in standby
mode, press the POWER (ON/STAND BY) or POWER
(ON) button for a minimum of 2 seconds when the
STATUS indicator goes off and the POWER indicator
starts blinking.
When the POWER indicator turns a steady green, and
the projector is ready to use.
• After you turn on your projector, ensure that the computer
or video source is turned on and that your lens cap is
removed.
NOTE: When no signal is available, a blue, black or logo screen is displayed.
ON/STAND BY
3D REFORM AUTO ADJUST SOURCE
Standby
LAMP
STATUS
POWER
ON/STAND BY
Steady green /
orange light
Press this button for a
minimum of 2 seconds.
(→ page 117)
24
PC CARD
LAMP
STATUS
POWER
POWER
OFF
COMPUTER
1
2
VIDEO
COMPONENT
S-VIDEO 3
PC CARD
LAMP
STATUS
POWER
SELECT
Blinking Power On
LAMP
STATUS
POWER
Blinking green Steady green
light
POWER
ON
VIEWER
LAN
LAMP
STATUS
POWER
light