Using Software Keyboard - NEC NP2000 User Manual

PC Control Connector (D-SUB 9P)
1 2 3
6 7
NOTE 1: Pins 1, 4, 6 and 9 are no used.
NOTE 2: Jumper "Request to Send" and "Clear to Send" together on both ends of the cable to simplify cable connection.
NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.

Using Software Keyboard

1 to 0 and Characters
.............................. Use to type in password or keyword.
MODE .................... Selects one of three modes for alphabet and special characters.
SP ......................... Inserts a space
BS ......................... Deletes one character backward
.......................... Returns to the previous
.......................... Advances to the next
OK ......................... Executes the selection
Cancel ................... Cancels the selection
NOTE: You can drag the Software keyboard on the screen by clicking and holding any part on the keyboard except buttons.
To TxD of PC
To RxD of PC
To GND of PC
4 5
8 9
To RTS of PC
To CTS of PC
128
9. Appendix