Dda Data Acquisition - Monster 659 Owner's Manual

DDA data acquisition

E
This function serves to activate the DDA (Ducati Data
Analyzer): the data logger must be connected to vehicle
wiring.
To enable this function, enter the menu and set "DDA" data
logger to "On" by holding switch (1, fig. 10) pressed in
position B "▼" for 3 seconds.
The START/STOP control for the data logger lap separator is
the high-beam flasher button FLASH (9, fig. 4) on the LH
switch.
If the DDA function is active and the display is suddenly
switched off (Key-Off), the function is switched off
automatically.
Note
Online assistance is available to Ducati Data Analyzer
(DDA) owners (http://dda.prosa.com). This service will
provide anything necessary to correctly use the DDA with
your PC: both for the device and the software for analysing
the recorded data.
Warning
After use, disconnect the DDA from the main wiring
harness.
36
MENU
Press B (for 3 secs.)
Press B (for 3 secs.)
fig. 28