Lap Timer - Monster 659 Owner's Manual

LAP timer

E
This function lets you display lap times.
To enable this function, enter the menu and set the "LAP"
function to "On" by holding switch (1, fig. 10) pressed in
position B "▼" for 3 seconds.
MENU
The lap timer is started and stopped using the high-beam
flasher button FLASH (12, fig. 5) on the LH switch.
When the LAP function is active, each time you press the
FLASH button, the display will show the lap time for 10
seconds, before reverting to normal mode.
Up to 30 lap times can be stored.
If the memory is full, each time you press the FLASH button,
Press B for 3 secs.
no more lap times can be saved and the display will show the
flashing message "FULL" for 3 seconds until the memory is
reset.
Press B for 3 secs.
fig. 25
33