Technical Data - Sanitas SFT41 Operating Instructions Manual

gets into the device, remove the battery immediately. Only use the
device again when it is completely dry.
Do not use any harsh cleaning agents.
Never immerse the device in water.
Always store the thermometer with the cap on in order to protect the
sensor.
The device must not be stored or used at too high or low a tempe-
rature or humidity (see technical specifications), in sunlight, in as-
sociation with an electrical current or in dusty locations. Otherwise,
inaccuracies can occur.
If prolonged storage is intended, you should remove the battery.
The device must be tested for accuracy (calibrated) after 3 years.
Please send the complete device to the dealer's or service address.
Please dispose of the device in accordance with the direc-
tive 2002/96/EG – WEEE (Waste Electrical and Electronic
Equipment). If you have any queries, please refer to the local
authorities responsible for waste disposal.

9. Technical data

Note: When the device is used outside the specifications, perfect
functioning cannot be guaranteed.
We reserve the right to make technical changes to improve and
develop the product.
Name and model
Measurement range
Laboratory measurement
precision
Interval between 2
measurements
Measurement units
Operating conditions
SFT41
Forehead thermometer mode: 34 °C to 42,2 °C
(93,2 °F to 108 °F)
SCAN mode: -22 °C – 80 °C (-7,6 °F – 176 °F)
Forehead thermometer mode: ±0,3 °C (±0,5 °F)
from 34 °C to 42,2°C (93,2 °F to 108 °F)
SCAN-Modus: ±0,3 °C from 22 °C to 42,2 °C
(71,6 °F to 108 °F)
±2 °C with >42,2 °C and <22 °C (>108 °F,
<71,6 °F)
At least 5 seconds
°Celsius (°C) or °Fahrenheit (°F)
10 °C to 40°C (50°F – 104°F) with a relative
humidity of 95% (non-condensing)
18