Advertisement
Standard 1.1
Close and latch the ferrite bead.
4
To install the Remote Gateway 911x unit on a desk, attach the rubber feet to the
bottom and continue with
refer to the Remote Gateway 911x Series Installation and Administration Guide
(555-8421-220).
To route calls over the IP network, or administer the Remote Gateway 911x series
unit from another location on the IP network, connect the unit to the Ethernet
network by doing the following:
Plug one end of a 10BaseT Ethernet cable (with an RJ-45 connector) to the
1
ETHERNET jack on the Remote Gateway 911x series unit.
Plug the other end of the 10BaseT Ethernet cable to either an Ethernet hub or
2
network router.
To connect the Remote Gateway 911x series unit to the analog line:
Plug the RJ-11 cable into the 911x unit LINE connector.
1
Plug the other end of the cable into the analog line jack.
2
Note: You may need to adjust the cable loops to make them as tight as
possible.
"
" on page
7. To install the Remote Gateway 911x unit on the wall,
Note: You must supply your own 10BaseT Ethernet cable with RJ-45
connectors. Contact your system administrator for the correct cable.
7
Advertisement
