Scanner Checkout; Scanner Checkout Procedures; System Software; System Verification - NCS Pearson 5000i Installation Manual

4. Scanner Checkout

This chapter discusses the procedures for scanner checkout, pre-installed system software,
system verification and backup, and customer hand-off.
Scanner Checkout Procedures{ XE "Scanner,
5000i:Checkout procedures" }{ XE "Software
checkout" }
To checkout the 5000i scanner, refer to the following sections in the Maintenance Manual for the
5000i Scanner.
®
1. Hopper and Stacker Operational Checkout (Section 2.6)
2. Sensor Checkout Procedures (Section 2.8)
3. Read Station Adjustments (Section 3.2)
4. Check Alignment test (Section 5.2.4.8)
5. Hopper Height Adjustments (Section 3.5)
6. Pick Area Adjustments (Section 3.3)
7. Calibrating (and Normalizing) the Scanner (Section E.2)

System Software

5000i scanner system software is pre-installed at NCS Pearson. For information regarding this
software{ XE "Checkout:Software" }, refer to the following publications:
•
Image ScanTools™ for 5000i
configuration. Error messages are not documented in this publication. Error messages are
displayed in On-Line Help.
•
NCS Accra™ - includes information on installation, setup, and configuration. Error messages
are not documented in this publication; error messages are displayed on Online Help.
System Verification{ XE "Checkout:System
verification" }
This section describes how to update the 5000i scanner system software.

Requirements

You need to have an additional 90 to 100 MB of disk space if you intend to maintain a copy of the
old and new software.
Page 36
Scanners - includes information on installation, setup, and
®
5000i Scanner Installation Guide