Table of Contents
Advertisement
Standalone Installation
The 5000i scanner in a standalone configuration requires a computer, a monitor, a keyboard, a
mouse, and a table (for the monitor, keyboard, and mouse). An optional printer may also be
installed.
Computer{ XE "Standalone installation:Computer" }
This section discusses installation and internal cabling for the computer in a standalone
configuration.
Installation
Before installing { XE "Computer:standalone checkout" }{ XE "Computer:Preparing for
standalone installation" }the computer in the scanner, do the following.
1.
Use your fingers (or a screwdriver) to remove the screw (knurled knob) at the rear of the
computer (center-top) and lift off the cover. Some models have green plastic covered
screws, and some have two screws.
CAUTION:
Use ESD precautions (including a grounded wrist strap) for
steps 2, 3, and 4.
2.
Make sure that the scanner interface cards and all ribbon cables are fully seated.
3.
Remove the Catgut board{ XE "Catgut board" } from its separate packaging and do the
following:
•
Ensure that the three 40-pin DIP and one 40-pin SIP headers which connect the
Catgut II board to the Catgut I board are fully seated.
•
Ensure that the SIMMs on the Catgut II{ XE "Daughter card (Catgut II)" }{ XE
"Catgut II (daughter card)" } board are fully seated.
Chapter 3. Computer and Peripherals Installation
Figure 3 – 1: Standalone Configuration
tiger009
Page 21
Advertisement
Table of Contents
