Table of Contents
Advertisement
1. Scanner Overview
This chapter presents an overview of the 5000i scanner and provides information on how to
receive technical support for hardware and software problems.
Overview of the Scanner{ XE "Scanner,
5000i:Overview" }
The 5000i is a device that captures the image{ XE "Image capture" \i } of a form. It sends that
image to a host computer for analysis. Figure 1-1 illustrates the parts of the scanner.
UPPER DEFLECTOR
INPUT DECK
INPUT HOPPER
LOWER DEFLECTOR COVER
OUTPUT HOPPER
OUTPUT DECK
POWER SWITCH
SELECT STACKER
SHUNT GATE
In a typical scanning session, these components function as follows:
•
The power switch { XE "Power switch" }turns on the scanner and any other system
components that are plugged into the scanner's internal power strip.
•
The READY switch { XE "READY switch" }starts and stops the scanner.
•
The input hopper { XE "Input hopper" \i }holds the forms that are ready to be scanned. When
the scanner is made READY, the input hopper raises; when the scanner stops, the hopper
lowers, allowing you to load more documents. The input hopper accepts stacks of up to 750
forms, depending on the thickness and condition of the sheets.
•
The input hopper height adjustment switch { XE "Input hopper height adjustment switch" \i
}allows you to adjust the height of the input hopper so that the scanner can pick a sheet. Refer
to the Operator's Guide for the 5000i
Chapter 1. Scanner Overview
Figure 1 – 1: Scanner Parts
Scanner for instructions on setting this adjustment.
TURNAROUND
PRINTER COVER
PRINTER DECK
tiger011
Page 1
Advertisement
Table of Contents
