2. Scanner Installation
This chapter describes how to set up and install the standalone 5000i scanner{ XE
"Installation:Scanner" },{ XE "Scanner installation:Introduction" } the computer, the monitor, and
the mouse.
The 5000i scanner system consists of the following { XE "Scanner installation:Components"
}components.
•
Model 5000i
•
Computer
•
SVGA monitor
•
Duplex Heads (InfraRed/Red Ink—I/R--heads)
•
Transport Printer (optional)
•
Bar Code (optional)
Preparation
Before assembling{ XE "Scanner installation:Preparation" } the standalone 5000i scanner, check to
make sure that you have all the hardware and accompanying documentation as listed below.
Hardware
•
Computer with SVGA monitor, keyboard, mouse, and furniture (standalone only)
Documentation: Manufacturer's user manuals
•
A model 5000i image scanner with interface card and cable
Documentation: Operator's Guide for the 5000i
5000i
Scanner
®
•
Normalization and Calibration forms packet
Documentation: Operator's Guide for the 5000i Scanner
Software
•
Microsoft
Windows NT
®
Documentation: NT User Guide
•
Scanner application software
Documentation: Image ScanTools™ User's Guide
•
Scanner Exerciser diagnostic software (or equivalent)
Documentation: Operator's Guide for the 5000i and Maintenance Manual for the 5000i
Scanner
Page 6
Scanner and the Maintenance Manual for the
®
software
®
5000i Scanner Installation Guide
®