Ncm Does Not Support Srg 1.0; Export When Voicemail Is Not Initialized; Ncm Netiq Ip Address Value; Extra Holiday Folders - Nortel Cartridge Installation Manual

NCM does not support SRG 1.0

Using NCM3.6 to apply the SRG 1.0 key code is not supported. If you choose to
apply the SRG 1.0 key code to your BCM devices using NCM3.6, you will
adversely affect your network.

Export when voicemail is not initialized

You can export voicemail changes to an uninitialized CallPilot (prior to running
the CallPilot wizard). However, such voicemail programming is activated upon
the initialization of CallPilot. (CR Q00677039)

NCM NetIQ IP address value

The * value is a valid input for NetIQ Authorized Management Servers in Unified
Manager. However, when you enter * as a value in NCM > Services > Net IQ IP,
and then export the configuration to a BCM device, the IP address field is left
blank. To properly export the field, enter a range of IP addresses in NCM3.6, or
configure the field in Unified Manager. (CR Q00842257)

Extra holiday folders

When you create a number of holiday folders under NCM > Voice Mail > Auto
Attendant > Holidays, without changing the defaults on each new holiday entry,
the newly configured holidays are not exported until the extraneous holiday
entries (those that are configured from the default) are deleted. (CR Q00837178)

H.323 trunks gatekeeper values blank

After importing a device to NCM, the H.323 Trunks Primary Gatekeeper IP,
Backup Gatekeeper IP, and Alias Names fields are all blank in NCM. Unified
Manager displays the default values for each field that is not set, but this behavior
does not translate to NCM. (CR Q00823461)
Release Notes and Cartridge Installation Guide for BCM3.7
27