Neopost DS-140 Operator's Manual page 53

Cleaning sensors (contd.)
Insert and collate area
For all positions shown, direct the jet of air onto the sensors, indicated by arrows in the
following views. Note that sensors are in two halves, receiver & transmitter - both halves
must be cleaned.
For the sensor pairs, liberally spray
the air jet in the gap between them.
feeders
140 Operator Manual
Open the perspex cover and front feeder
cover, then lift the front-most green
handle to raise the mechanism - this is
held in the raised position by a latch.
Lower the feeder side cover and
raise the top cover. Swing the
green latch upwards to raise the
roller platten.
note: station 1 feeder is shown -
others are similar.
53