Philips GC6600 series User Manual page 9

Problem
Water droplets
come out of the
soleplate.
Water flushes out
of the soleplate.
The Calc-Clean
process does not
start.
Possible cause
After the Calc-Clean process,
remaining water may drip out
of the soleplate.
The Calc-Clean process has
not been completed.
You have accidentally started
the Calc-Clean process (see
chapter 'IMPORTANT -
Cleaning and maintenance').
You have not set the
temperature dial to CALC
CLEAN or you have not
waited for the iron to heat up.
You have not pressed the
Calc-Clean button for
2 seconds until the appliance
started beeping.
Solution
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still flashes and
the appliance still beeps, perform the Calc-
Clean process (see chapter 'IMPORTANT -
Cleaning and maintenance').
You have to perform the Calc-Clean
process again (see chapter 'IMPORTANT -
Cleaning and maintenance').
Switch off the appliance. Then switch it back
on again. Turn the temperature dial to the
desired temperature setting instead of
CÁLC CLEAN. Let the iron heat up until
the 'iron ready' light lights up steadily.
See chapter 'IMPORTANT - Cleaning and
maintenance'.
See chapter 'IMPORTANT - Cleaning and
maintenance'.
ENGLISH
9