D-Link DIR-822 User Manual page 43

Section 4 - Configuration
Select PPPoE if your Internet connection requires you to enter a username and password. This information is provided by your Internet Service
Provider (ISP).
PPPoE Session: Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
If you selected Create a new session above, enter the PPPoE
Username:
username provided by your ISP here.
Password: If you selected Create a new session above, enter the PPPoE
password provided by your ISP here.
Select Static IP if your ISP assigned you the IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP (Static IP only).
DNS Type: Select either Obtain DNS server address automatically or Use the
following DNS address.
If you selected Use the following DNS address above, enter the
Primary DNS
Server: primary DNS server address.
Secondary DNS If you selected Use the following DNS address above, enter the
Server: secondary DNS server address.
Enable DHCP- Enable or disable DHCP-PD for other IPv6 routers connected to the
PD: LAN interface.
Note: This feature requires a smaller subnet prefix than /64 (i.e. allowing
for a larger address allocation), such as /63. Contact your ISP for more
information.
D-Link DIR-822 User Manual
PPPoE
39