Maintenance; Operation - Makita 9564PC Instruction Manual

Installing or removing diamond wheel
(accessory)
CAUTION:
Make sure that the arrow on the tool should point in
•
the same direction as the arrow on the diamond
wheel.
Fig.10
Mount the inner flange onto the spindle. Fit the diamond
wheel on over the inner flange and screw the lock nut
onto the spindle. Notice that flat side of the lock nut
should face the diamond wheel in case the diamond
wheel is used.

OPERATION

WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
NEVER bang or hit grinding disc or wheel onto
•
work.
Avoid bouncing and snagging the wheel, especially
•
when working corners, sharp edges etc. This can
cause loss of control and kickback.
NEVER use tool with wood cutting blades and
•
other sawblades. Such blades when used on a
grinder frequently kick and cause loss of control
leading to personal injury.
CAUTION:
After operation, always switch off the tool and wait
•
until the wheel has come to a complete stop before
putting the tool down.
Grinding and sanding operation
Fig.11
ALWAYS hold the tool firmly with one hand on housing
and the other on the side handle. Turn the tool on and
then apply the wheel or disc to the workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15 degrees to the workpiece surface.
During the break-in period with a new wheel, do not work
the grinder in the B direction or it will cut into the
workpiece. Once the edge of the wheel has been
rounded off by use, the wheel may be worked in both A
and B direction.
Operation with diamond wheel (accessory )
WARNING:
Forcing and exerting excessive pressure or
•
allowing the wheel to bend, pinch or twist in the cut
can cause overheating of the motor and dangerous
kickback of the tool.
CAUTION:
After cutting operation, make sure that the
•
diamond wheel stops revolving completely. Then,
place the tool. It is dangerous to place the tool
before turning off the tool. If there are dust or dirt
around the tool, the tool may suck in them.
Be sure that the wheel does not contact the workpiece.
Turn the tool on and hold the tool firmly. Wait until the
wheel attains full speed. Now simply move the tool
forward over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Fig.12
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Wheel guard (Wheel cover)
•
Inner flange
•
Depressed center wheels
•
Lock nut (For depressed center wheel)
•
Rubber pad
•
Abrasive discs
•
Lock nut (For abrasive disc)
•
Lock nut wrench
•
Wire cup brush
•
Wire bevel brush 85
•
Side grip
•
Dust collecting wheel guard
•
8
or attachments
Only use accessory or
are